SAMPLE — NOT FOR JOBSITE USE
Electrical demolition JHA Example
This educational electrical example is generated from draft bank version 2026.07.20-ai1 and remains noindex until safety review.
| Clause | Control | Citation |
|---|---|---|
| CTL-ELEC-001 | No employer shall permit an employee to work in such proximity to any part of an electric power circuit that the employee could contact the circuit in the course of work, unless the employee is protected against electric shock by deenergizing the circuit and grounding it or by guarding it effectively by insulation or other means. | 29 CFR 1926.416(a)(1) |
| CTL-ELEC-002 | Controls to be deactivated during work on energized or deenergized equipment or circuits shall be tagged; deenergized equipment or circuits shall be rendered inoperative and shall have tags attached at all points where they can be energized, and tags shall be placed to identify plainly the equipment or circuits being worked on. | 29 CFR 1926.417(a); 29 CFR 1926.417(b); 29 CFR 1926.417(c) |
| CTL-ELEC-003 | All 120-volt, single-phase, 15- and 20-ampere receptacle outlets that are not part of the permanent wiring of the building or structure and that are in use by employees shall have approved ground-fault circuit interrupters for personnel protection, or the employer shall establish and implement an assured equipment grounding conductor program. | 29 CFR 1926.404(b)(1)(ii); 29 CFR 1926.404(b)(1)(iii) |
| CTL-PPE-001 | Employees exposed to possible danger of head injury from impact, falling or flying objects, or electrical shock and burns shall be protected by protective helmets. | 29 CFR 1926.100(a) |
| CTL-PPE-002 | Where there is a potential for objects falling to a lower level, each exposed employee shall wear a hard hat, and the employer shall erect toeboards, screens, or guardrail systems to prevent objects from falling, or erect canopy structures and keep potential fall objects far enough from the edge, or barricade the area to which objects could fall and prohibit employees from entering it. | 29 CFR 1926.501(c); 29 CFR 1926.502(j) |