SAMPLE — NOT FOR JOBSITE USE
Lighting fixture installation JHA Example
This educational electrical example is generated from draft bank version 2026.07.20-ai1 and remains noindex until safety review.
| Clause | Control | Citation |
|---|---|---|
| CTL-ELEC-001 | No employer shall permit an employee to work in such proximity to any part of an electric power circuit that the employee could contact the circuit in the course of work, unless the employee is protected against electric shock by deenergizing the circuit and grounding it or by guarding it effectively by insulation or other means. | 29 CFR 1926.416(a)(1) |
| CTL-ELEC-002 | Controls to be deactivated during work on energized or deenergized equipment or circuits shall be tagged; deenergized equipment or circuits shall be rendered inoperative and shall have tags attached at all points where they can be energized, and tags shall be placed to identify plainly the equipment or circuits being worked on. | 29 CFR 1926.417(a); 29 CFR 1926.417(b); 29 CFR 1926.417(c) |
| CTL-ELEC-003 | All 120-volt, single-phase, 15- and 20-ampere receptacle outlets that are not part of the permanent wiring of the building or structure and that are in use by employees shall have approved ground-fault circuit interrupters for personnel protection, or the employer shall establish and implement an assured equipment grounding conductor program. | 29 CFR 1926.404(b)(1)(ii); 29 CFR 1926.404(b)(1)(iii) |
| CTL-LADDER-001 | Ladders shall be inspected periodically by a competent person and after any occurrence that could affect their safe use; ladders with structural defects shall be withdrawn from service. | 29 CFR 1926.1053(b)(15); 29 CFR 1926.1053(b)(16) |
| CTL-LADDER-002 | When a portable ladder is used for access to an upper landing surface, its side rails shall extend at least 3 feet above that surface; where that is not possible, the ladder shall be secured at its top to a rigid support and a grasping device shall be provided to assist mounting and dismounting. | 29 CFR 1926.1053(b)(1) |
| CTL-LADDER-003 | Ladders shall have nonconductive side rails if they are used where the employee or the ladder could contact exposed energized electrical equipment. | 29 CFR 1926.1053(b)(12) |