SAMPLE — NOT FOR JOBSITE USE
Roof access and egress JHA Example
This educational roofing example is generated from source-mapped clause bank version 2026.08.28-ai3.
| Clause | Control | Citation |
|---|---|---|
| CTL-FALL-001 | Employees on walking or working surfaces with unprotected sides or edges 6 feet or more above a lower level shall be protected by guardrail systems, safety net systems, or personal fall arrest systems unless a specific Subpart M alternative applies. | 29 CFR 1926.501(b)(1) |
| CTL-FALL-002 | Personal fall arrest systems shall be inspected before each use for wear, damage, and other deterioration, and defective components shall be removed from service. | 29 CFR 1926.502(d)(21) |
| CTL-FALL-004 | Anchorages used for attachment of personal fall arrest equipment shall be independent of any anchorage being used to support or suspend platforms and capable of supporting at least 5,000 pounds per employee attached, or shall be designed, installed, and used as part of a complete personal fall arrest system that maintains a safety factor of at least two, under the supervision of a qualified person. | 29 CFR 1926.502(d)(15) |
| CTL-HEAT-001 (recommended practice) | The employer heat-illness prevention plan should account for heat conditions and workload; provide adequate cool drinking water, rest breaks, and a shaded or cool recovery area; gradually acclimatize new and returning workers; train workers and supervisors to recognize and respond to heat illness; and require 911 activation with immediate aggressive cooling for suspected heat stroke. | Recommended practice OSH Act Section 5(a)(1); OSHA Heat Exposure prevention guidance |
| CTL-LADDER-001 | Ladders shall be inspected periodically by a competent person and after any occurrence that could affect their safe use; ladders with structural defects shall be withdrawn from service. | 29 CFR 1926.1053(b)(15); 29 CFR 1926.1053(b)(16) |
| CTL-LADDER-002 | When a portable ladder is used for access to an upper landing surface, its side rails shall extend at least 3 feet above that surface; where that extension is not possible because of the ladder's length, the ladder shall be secured at its top to a rigid support that will not deflect, and a grasping device shall be provided to assist mounting and dismounting. | 29 CFR 1926.1053(b)(1) |
